| 详细介绍：
台仪温控仪FY400-103000河北一级供应商
联系人：魏工 电话：15882174684
座机：028-84472033
QQ：2030149354
产品资料：
Segment Dwell
Time
º The time (hh:mm:ss) to maintain the current setpoint if the segment
type is Dwell.
Profile Header: Settings that apply to the chosen profile as a whole
Enter Profile Name º Up to 16 characters can be used to name each profile
Profile Starting
Point
º The setpoint value to be used at the beginning of the first segment.
From: Actual Setpoint or Process Variable value at the time the
profile starts.
Profile Start
Trigger
º From: None (profile start is not delayed); After Delay or Day and
Time (Recorder version only).
Profile Start Time º The time (hh:mm:ss) when the profile should run. – This applies only
if Day and Time is the Profile Start Trigger. Caution: Take care not
to clash with other profiles. A Profile cannot start if another is
running.
Profile Start Day(s) º The Day(s) when the profile should run. From: Mon; Tue; Wed; Thu;
Fri; Sat; Sun; Mon-Fri; Mon-Sat; Sat-Sun or All. – This applies only if
Day and Time is the Profile Start Trigger.
Profile Start Delay º The delay time, up to 99:59 (hh:mm), for a profile to begin after the
start request has been given.
Profile Recovery
Method
º The power-on action if profile was running at power-down (e.g. after
a power cut), or following correction of a signal break. From: Control
outputs off; Restart profile from the beginning; Maintain last profile
setpoint; Use controller setpoint; Continue profile from where it was
when power failed.
Profile Recovery
Time
º The Recovery Method is ignored (the profile continues from where
power failed), if power off for less than this time. Max 99:59
(hh:mm). - Recorder version only.
Profile Abort
Action
º Action after profile has been forced to stop before its end. From:
Control outputs off; Maintain last profile setpoint or Use controller
setpoint.
Profile Cycles º The number of times the program should run each time it is started
(1-9999 or Infinite).
Profile Segment Details
| 
放大图片
暂无相关下载
