简要说明：台达牌的台达驱动器ECMA-E11310SS产品：估价：1，规格：ECMA-E11310SS，产品系列编号：15882174684

台达驱动器ECMA-E11310SS
联系人：魏工    电话：15882174684 
            座机：028-84472033  QQ：2030149354
产品资料：

•Choose the waterproof bushing type according to the cable

size.

<External diameter of cable: In case of 3 to 5 mm>

Use the cap unit in the delivery state.

<External diameter of cable: In case of 5 to 8 mm>

When using, pick tab both sides of the waterproof bushing

with a tab and pull it out in the direction of an arrow.

Note: When it isn't necessary to pull out bushing, do not pull a tab or pull out

bushing carelessly. Do not insert the pulled-out bushing again.

(4) Cable insertion

•Insert a cable in the cap unit.

(5) Wiring

•Confirm the terminal number indication*1 of a IDC

(Insulation Displacement Contact) cover, insert a core wire

in each wire guide according to the terminal number and

push in to the lowermost part of a core wire storage part.

(6) Processing the core wire end

•Cut the end part of each core wire with nippers. Cutting the

core wire end in the range of cut-area of figure.

Note: Please be careful not to cut the boss.

(7) Assembling the Contact block

• Insert the cap unit core wire end processing has completed

in a contact block.

•Use a mark of a housing and an arrow of a IDC cover, as

a guideline of alignment. The location of the arrow is the

side of the terminal No.1.

Note: Confirm that the color of the housing and the IDC cover is same before

insertion.

(8) Tightening up the cap

•After inserting the cap unit and tightening a screw up lightly

by hand, screw up the cap by a tool of a spanner or wrench

(size 15 mm).*2

•When a gap between a mold cover of contact block and a

cap disappeared assembly and wire connection has

completed.

Note 1. When the operation has completed, mark of cap comes into the

square of the indicator formed into a mold cover ( ), so also use

it as guideline to know to complete.

2. Avoid tightening a cap up beyond the completion position. It may cause

damage.

(9) Final checking

•When the connector has been assembled, make sure the

line insulation is as specified.

(1) Connector and Cable External Diameters